This Experiment Marcet Boiler Engineering Essay

This Experiment Marcet Boiler Engineering Essay In This experiment a Marcet boiler was used to conduct the relationship between a saturated pressure and temperature of water in the range of 0-14 bar indicating in the gauge and also to determine the temperature of a body when being heated or cooled. When the temperature increases pressure also increases in this case the relationship between pressure and temperature is directly proportional. Assumption was made that the temperature is uniform throughout the boiler and the outside surface temperature of the boiler is the same as the steam temperature. Theoretically, the values from the steam table should almost be the same with the recorded values. In this case, if the values are not the same then this is due to error that was made in the experiment. The experiment was performed carefully and all procedure was followed to get accurate result. First of all the startup procedure is to fill water in Marcet boiler and the water level is half of the boilers height. Then the supply switch was turned on. It is important to remove the air in the boiler in this case the valve would be open from the start up of the experiment When the temperature increases to 100Â °C, the steam is allowed to come out from the valve for few seconds and close the valve. Record the steam temperature and pressure reaches 14 bars. Introduction Thermodynamics is the study of heat and in relation in other form of work and energy between a system and its surrounding; in this case the property in the system will change. Generally ideal gas obeys the equation of state which is showed below. PV= When energy is increased in the water .the molecules in the water that is increasing will enable the molecules to escape from the surface until it is in equilibrium (boiling point). The state of equilibrium depends on the pressure in the surface of the water. When the pressure is low it is easier for the molecules to leave the water with less energy. The Marcet boiler is used to investigate the relationship pressure and temperature in saturated steam for comparison with the steam table .the experiment slope (dT/dp) is obtained water at saturated temperature Theory The Marcet boiler is used to investigate the between pressure and temperature of saturated steam, in equilibrium with water, at all pressures between atmospheric and a 14bar An ideal gas can be characterized by three state variables: absolute pressure (P), volume (V), and absolute temperature (T). The relationship between them may be deduced from kinetic theory and is called the Ideal Gas law. The ideal gas law was originally determined empirically and is simply. and hf + hfg = hg Æ’Å ¾ hf as vg >> vf In which, vf = specific volume of saturated liquid vg = specific volume of saturated vapor hf = enthalpy of saturated liquid hg = enthalpy of saturated vapor hfg = latent heat of vaporization Equipment Procedure Fill up water half the height of the boiler Ensure the valve is opened Connect the boiler to the electrical switch The boiler is heated up to 100Â °c and the steam will come out of the open valve Close the valve after 1 minutes to ensure that the air in the boiler is out and continues heating When the pressure start rising , start the stop watch Record all the temperature readings at different pressure with time Pressure must not exceed 14 bar Discussion The theory can be compared with the experiment where pressure and temperature are directly proportional to each other When a water is heated in a container to a boiling point the tempreture increases and presussre also increase in the case where the steam is closed in a cylinder, Their will be internal pressure in the container and also internal forces. it is shown in the graph that tempreture is relatively proportional to pressure In the table error was zero because the decreasing tempreture of the boiler was not noted down therefore erro is unknown . assuming the decreasing tempreture is considered the the error percentage would now exceed 10% because the experiment was done in a closed system so no amount of volume will escape It was important to remove the air from the boiler to avoid flaws of readings . Marcet boiler is used in plant steam industries, power plant, cooking utensil and so on Conclusion in the experiment, it shows from the table and theory that temperature and pressure is relatively proportional in balance with water Disgracing some negligible faults, this experiment can be consider successful, to improve the result of the experiment, it should be carried out at room temperature switching off all the air-conditions, and also by repeating the experiment and taking the average value. If some insulation were kept on theMarcet boiler to reduce heat loss, the experiment could be more accurate